![]() The array has been created, it remains to mark it up in disk management. Next, click on Create logical Drive, select the type, number of groups, block size, if necessary, set a specific size, activate caching, and then Save to confirm. On the Configuration tab, select your controller, on the right side of the window, click Create Array.Ĭheck the media that your future RAID will consist of and click Ok. In order to assemble an array from a loaded operating system, use the HP Array Configuration Utility or HPE Smart Storage Administrator, which can be downloaded from the official website of the controller manufacturer. Then you just need to go into disk management and mark it by assigning a letter to it and selecting the file system.Ĭollecting an Array Using the HP Array Configuration Utility To view information about the array, open View logical Drive, if everything is correct, press the Esc key to exit the settings menu and further boot. To confirm the configuration write press F8 and Enter to continue. ![]() After setting all the settings, press Enter, after which information, size, type and so on will be displayed. Press the Tab key to go to the next section of the settings, set the checkbox opposite the desired type, choose from how many groups it will consist of, in the case of two, since I have only 6 disks. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
May 2023
Categories |